...........

Image and video hosting by TinyPic

Pages

Showing posts with label M. Show all posts
Showing posts with label M. Show all posts

Friday, 10 June 2011

Melody Music Generation Using M348X CMOS IC


Melody Music Generation Project
The M348X series is a mask-ROM-programmed multi-instrument melody generator , implemented by CMOS technology. It is designed to play the melody according to the previously programmed information. The device also includes a pre-amplifierwhich provides a simple interface to the driver circuit. The M348X series is intended for applications such as toys, doorbells, music box, melody clock/timers and telephones.
This project based on the M348X IC is the electronic equivalent of a mechanical music box. It has a range of tunes and isactivated by light falling on a light dependent resistor (LDR) sensor. It can be placed anywhere that you want a tune to play when light falls on it: a cupboard, music box. There could be some applications where the LDR is replaced by a switchor a push-button.
Christmas music is available when M3481 is used.
Jingle Bells
Santa Claus Is Coming To Town
Silent Night, Holy Night
Joy To The World
Rudolph, The Red-nosed Reindeer
We Wish You A Merry Christmas
O Come, All Ye Faithful
Hark, The Herald Angels Sing

The following music is available when M3485 is used.

The Hawaiian Wedding Song
Try To Remember
Aloha OE
Butterfly Love Story
Yesterday





Melody Music Generation DescriptionWhen light falls on the LDR, the music IC is enabled by the positive potential appearing on pin 2. The sensitivityof the LDR can be changed by varying the value of the 100K in the SIL connected to pin 2. A tune is selected bypushing the PCB-mounted tact switch. The jumper J1 determines whether the selected tune will play continuously or will cycle through all the tunes available in the IC. The musical pitch is determined by the resistor R1. Decreasing the value of R1 lowers the pitch, and each tune takes longer to play. The RC network at pin 7 shapes the sound. The speaker is drivenby a complementary pair of transistors driven by the IC. Negative feedback is provided by R3 to stabilise the DC voltage atthe emitters of Q1 & Q2.
Jumper J2 selects whether or not a tune stops immediately when light is removed from the LDR, or it plays right through to its end before stopping. In the idle state the circuit draws about 50uA, and about 20mA when it is operating. Therefore,there is no need for an off/on switch.

Melody Music Parts List
The parts list for the project is as shown below.

 

Message Recorder Digital Electronics Project


Introduction
The purpose of this digital electronics project is to record messages using a dedicated voice recorder integrated circuit. Recordings are stored in a non volatile memory cells, which means that the message will still be saved even though power has been removed from the device.
Winbond’s ISD2500 Series provide high-quality, single-chip, Record/Playbacksolutions for 60 seconds to 120 seconds message applications. The CMOS devices include an on-chip oscillator, microphone preamplifier, automatic gain control, antialiasing filter, smoothing filter, speaker amplifier, and high density multi-level storage array. In addition, the ISD2500 is microcontrollercompatible, allowing complex messaging and addressing to be achieved. Recordings are stored into on-chip nonvolatile memory cells.

Circuit Description




The ISD25120 has several modes of operation. The mode used here is as a multi-message recorder. You may record as many messages as you want up to 120 seconds of memory space.Put the SPDT switch into the Record position and just push & release the Start/Pause button to start recording. The Record LED goes on. Push the Start/Pause button to Pause - stop recording. That is the end of Message 1. Sometime later you can record a follow on message, Message 2, by pushing the Start/Pause button again. When you put the switch to Play the messageswill playback. Only one message will be played back at a time. You must push Start/Pause again to get the next message. The Reset switch will move the internal address pointer back to the start of the memory space.

Parts List
The parts list of the message recorder is shown as below.



The complete specifications of the Winbond ISD25120 IC can be obtained fromISD25120 Digital Electronics Project Specifications. 

Multi-Melody Generator


Medium Power FM Transmitter


Saturday, 28 May 2011

Muscular Stimulator


Motorbike Alarm


Mobile Shield


Mobile Bug


Midnight Security Light


Monday, 23 May 2011

Multi tone Siren


Mini Ups System

Click On The Image

Mobile Electric Workbench

Click On th Image

Sunday, 15 May 2011

Motion Sensor For Security Light

Click On The Image To Enlarge

Mobile Car Stereo Player

Click on The Image To Enlarge